#What can make ironing look like this?

1 messages · Page 1 of 1 (latest)

high knot
#

Hello, I need some help calibrating ironing on my printer. What can cause this?

IMG_20250114_183938.jpg
hollow joltBOT
#
AI Help

Calibrating ironing involves adjusting parameters such as flow rate, temperature, speed, and layer height. Issues with ironing can be caused by incorrect settings or a misaligned printer. Make sure that your slicer software is set up correctly and that the printer's hardware is in good condition. Adjusting the relevant parameters should help improve the ironing quality.

WARNING: This response is AI generated and may contain errors.
high knot
#

Printer is Artillery sidewinder x1, no mods, default firmware(?), eSUN PLA+, cura