Elegoo Neptune 3 Pro - bad bed adhesion | 3D Printing | Page 1

muted sorrel Jan 9, 2025, 3:25 AM

#

Printer is supposed to have auto leveling, but I suspect it either doesn't save or doesn't load the mesh. I tried putting M501 in the start Gcode, which just crashed the nozzle into the bed.

scarlet sedgeBOT Jan 9, 2025, 3:25 AM

#

muted sorrel Printer is supposed to have auto leveling, but I suspect it either doesn't save ...

#

AI Help

It sounds like there may be an issue with the auto bed leveling feature on your printer. Make sure the firmware supports this feature and is correctly configured. Try resetting the printer and re-running the bed leveling procedure. I would recommend reaching out to the manufacturer or an experienced technician for further troubleshooting.

scarlet sedgeBOT Jan 9, 2025, 5:27 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

muted sorrel Jan 9, 2025, 2:41 PM

#

Plz help meeeeeeeeee

sweet portal Jan 9, 2025, 3:29 PM

#

do you even know what firmware you have

deft dune Jan 9, 2025, 3:30 PM

#

You need to issue M420 S1 after homing

sweet portal Jan 9, 2025, 3:30 PM

#

for Klipper, it has to be enabled with a [bed_mesh] and a [probe] section, the use BED_MESH_CALIBRATE.
for Marlin, it must be compiled in with probe support, and issue G29, then M420 S1

deft dune Jan 9, 2025, 3:31 PM

#

M501 loads the last bed mesh (if it was saved in the first place) but doesn't activate it which is what M420 does

#

https://marlinfw.org/docs/features/auto_bed_leveling.html

Marlin Firmware

Automatic Bed Leveling

Automated procedures to probe the bed and compensate for an irregular or tilted bed

#Elegoo Neptune 3 Pro - bad bed adhesion