HueForge

[tawdry tree]

I made a picture from HueForge and followed the instructions per the software. The black layer (the first layer) is pretty thin.

Anyone know how in BambuStudio can I make the first initial layer thicker without changing the look of the image? Plus it was pretty difficult to pull off due to the layer being thin.

(Bambu P1S)

[rigid bough]

AI Help

It seems like you may be experiencing issues with your printer's initial layer adhesion. To adjust the initial layer thickness without changing the overall appearance of the image in BambuStudio, you can try adjusting the initial layer height setting in your slicer software. This setting controls how thick the first layer will be printed.

However, if you're having trouble with adhesion, it's also important to ensure that your printer bed is properly leveled and that the nozzle height is set correctly. Additionally, using a brim or raft can help improve adhesion for the initial layer.

If these suggestions don't solve your issue, feel free to provide more details so I can assist you further.

WARNING: This response is AI generated and may contain errors.

[rigid bough]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[dapper sphinx]

This may be better asked on the hueforge discord