#how can i stop my prints from fusing with each other

1 messages · Page 1 of 1 (latest)

turbid walrus
#

sovol sv06 trying to print the katana test with prusaslicer 2.9.0

IMG_6410.jpeg
finite owlBOT
#
AI Help

To print the katana test file on your Sovol SV06 using PrusaSlicer 2.9.0, you can follow these steps:

  1. Open PrusaSlicer and import the katana test file.
  2. Configure your print settings, including layer height, infill percentage, and print speed.
  3. Make sure to generate supports if needed, based on the model.
  4. Slice the model and save the G-code file.
  5. Transfer the G-code file to your printer's SD card.
  6. Insert the SD card into your Sovol SV06 and start the print.

If you encounter any specific issues during the process or have questions about a certain step, feel free to ask for further assistance!

WARNING: This response is AI generated and may contain errors.
turbid walrus
#

i did add a scarf all it did is make the line smaller

turbid walrus
#

i have no idea on how to make it stop so any idea will help

finite owlBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

sonic perch
#

Sv06 + pla i've had this and not fixed it yet.

But i've heard if you find a setting "horizontal expansion" and reduce it, it can fix this.

finite owlBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

turbid walrus
sonic perch
turbid walrus
#

ok i'll test it out and tell ytou how it goes

turbid walrus
#

do you use cura by chance?

sonic perch
turbid walrus
#

THANK YOU SO SO MUCH YOU DONT KNOW HOW MUCH OF A PROBLEM IT WAS

#

?solved