Bambu studio slicing parts

[nova flame]

After slicing the plate it has there weird randoms areas that aren't as smooth as the others. Printing with 25% infill with rectilinear pattern.

[worthy perch]

AI Help

It sounds like you may be experiencing issues with uneven extrusion or inconsistent temperature during printing. Here are a few troubleshooting steps you can try:

1. Check your printer's nozzle for any clogs or debris that may be affecting the extrusion.
2. Make sure your filament is of good quality and not tangled or worn out.
3. Clean the build plate to ensure proper adhesion.
4. Verify that your printer's temperature settings are correct for the filament type you are using.
5. Adjust the print speed and flow rate settings in your slicer software to see if that improves the print quality.

If the issue persists, you may need to fine-tune your printer settings or investigate other potential causes such as belt tension or Z-axis alignment.

WARNING: This response is AI generated and may contain errors.

[drowsy pumice]

Did you make this model yourself? It probably has some weird geometries that throw the slicer off. Or its a slicer bug which you can resolve by slightly moving or rotating the part or fiddling with the layer height.