Sv06 ace | 3D Printing | Page 1

torn berry Dec 28, 2024, 6:22 AM

#

So, I’ve sliced a benchy file in octo and the printer is attempting to print off of the actual print base, which is borderline confusing. It does all that it should, then starts making irrational movements, prints mid air and jerks around so much that the filament comes out like a scene out of the botched robocop trials. Any idea?

gusty kindleBOT Dec 28, 2024, 6:22 AM

#

torn berry So, I’ve sliced a benchy file in octo and the printer is attempting to print off...

#

AI Help

It sounds like there may be an issue with your print bed leveling or calibration. Make sure your print bed is leveled properly. Also, ensure that your slicer settings match the specifications of your printer. Check that the nozzle is at the correct height above the print bed at the start of the print. Lastly, consider updating the firmware of your 3D printer to ensure it is functioning correctly.

rancid violet Dec 28, 2024, 6:40 AM

#

The settings need to be adjusted for the print bed size (235 x 235 x 300mm) and location for this printer.

Both in octoprint, and any slicer you might use.

Also, while i'm not entirely sure, some of the axis's are set up are "reverse or backwards" in this printer. This might need more looking into though.

torn berry Dec 28, 2024, 6:43 AM

#

I’m going to let it run for 13 mins and then see what happens. Afterwards, I’ll edit

rancid violet Dec 28, 2024, 6:44 AM

#

Otherwise...does it do this without octoprint?

torn berry Dec 28, 2024, 6:44 AM

#

I can’t run any other software so idk

#

I’m running a 2007 office pc

#

@rancid violet it worked

#

I just didn’t give it a chance

#

rancid violet Dec 28, 2024, 7:06 AM

#

Oh nice!
May need to look at adjusting the position of the belts in the printer menu 😅
I'm not running an ace, so i'm not quite sure where it is...

torn berry Dec 28, 2024, 7:08 AM

#

#

@rancid violet

#

It worked as it should’ve

rancid violet Dec 28, 2024, 7:10 AM

#

Yah nice!

But i'm more referring to violent noises you described earlier 😅

torn berry Dec 28, 2024, 7:10 AM

#

Oh that was actually just it finishing calibration

#

It prematurely stopped itself calibrating

rancid violet Dec 28, 2024, 7:17 AM

#

oh... woah... so the ace auto calibrates... 👀
ok i need to go learn more about this printer I think...

#Sv06 ace