Ender 3 is being a dumbass | 3D Printing | Page 1

visual talon Dec 24, 2024, 7:38 AM

#

This funcker doesn't wanna print, filament is not extruding, PLA. It extrudes when I move the extruder wheel (digitally).

nova cairnBOT Dec 24, 2024, 7:38 AM

#

#

AI Help

Here are a few troubleshooting steps you can try:

Check if the nozzle is clogged: Heat up the nozzle, manually push the filament through, or use a nozzle cleaning kit to unclog it.
Check the filament feeding mechanism: Make sure the filament is loaded correctly and that the extruder motor is functioning.
Adjust the nozzle temperature: Sometimes PLA filament requires a slightly higher temperature to properly extrude.
Ensure the filament isn't tangled or stuck: Ensure the filament spool can rotate freely and isn't creating any resistance.

If these steps don't resolve the issue, please provide more details for further assistance.

visual talon Dec 24, 2024, 7:40 AM

#

someone pls help??

nova cairnBOT Dec 24, 2024, 9:43 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

nova cairnBOT Dec 24, 2024, 11:48 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

limber hearth Dec 24, 2024, 5:27 PM

#

theres really not mcuh to go on.

So, you could have a clog..

#

there could be a piece of plastic in the filiment feed gears, if its cliking thats a possibility,

#

If its not actually riving the filiment gears then the issue lies elswhere

#Ender 3 is being a dumbass