Now wtf is going on???? Random under extrusion?

[harsh ruin]

I leveled it perfectly, this is after I fixed the hotend fan, switched to direct drive, changed filaments, and leveled it perfectly. No fucking clue what’s going on

[fast nova]

AI Help

It sounds like you've already gone through some troubleshooting steps to address the issue. Without more information about the specific problem you're encountering, it's hard to suggest additional solutions. Feel free to provide more details so I can assist you further.

WARNING: This response is AI generated and may contain errors.

[harsh ruin]

Ender 3 with pro touchpad, cura (also tried prusaslicer)

@dawn spear

[heady zodiac]

you got a bed probe?

[harsh ruin]

I don’t

As in like a BLTouch?

[heady zodiac]

Your bed is pillowing out in the middle

Its lower on the sides than the middle

If you don't wan't to install a BLTouch or similar, you can shim the bed with aluminium tape or similar to make it even when heated up

[harsh ruin]

Damn

I’m dumping so much money into this ender

[heady zodiac]

Welcome to the hobby🥲

[harsh ruin]

@heady zodiac

I tried installing the bltouch firmware and it does this weird shit now

[heady zodiac]

Do you have the sensor or not? The firmware is pretty useless without it

[harsh ruin]

Its coming tomorrow

Might as well do this now

[heady zodiac]

You may need to update the screens firmware

[harsh ruin]

Ok I figured it out but now none of my axises want to move

[heady zodiac]

Its probably expecting a bltouch, which isn't attached

[harsh ruin]

Perchance

But even if I auto home it doesn’t move

[harsh ruin]

Installed the non bl touch version and it still doesn’t wanna move

figured it out again