#Wago anbd wire fna shenanagins

1 messages · Page 1 of 1 (latest)

uncut rock
#

Here

stuck flumeBOT
#
AI Help

Hello! How can I help you today with 3D printing?

WARNING: This response is AI generated and may contain errors.
uncut rock
#

So I;m happy with the ago

#

wago

#

But question is what cables do I get and how to use them... so to speak?

#

The fans are the normal 2 pin conenctors

#

I can order these wires

#

If I use the female one and connect it to the fan itself

#

then what do I do with the end? with the + and -

#

as in

#

Is one hole for + and is one hole for -?

#

and is there a port for the wire behind it?

#

@obtuse jolt

obtuse jolt
uncut rock
#

I see, I see

#

tysm brother, sorry for having to cope with my slowness

#

I'll get 2x of these

image.png
obtuse jolt
#

np, it's goo to be sure

#

idk which ones are those

#

get the latch ones I sent

uncut rock
#

Sure

#

This?

obtuse jolt
#

yup

uncut rock
#

wonderful

obtuse jolt
#

this'll even do mains and higher power stuff as well

uncut rock
#

300V is a lil overkill

#

but will do

obtuse jolt
#

that's why you could use the clones that just do Y split

#

for fans and stuff it's totally fine

#

the Y split I was talking about

image.png
uncut rock
#

I'll get these wires

#

I'll be handy just to have around as well as use them

obtuse jolt
#

depending on how much custom wiring you'll do you can also get a crimper

uncut rock
obtuse jolt
#

then sure those will do

uncut rock
#

I can't believe I've been running a singular 4010 for how long

#

And not pondered on the horrido verhangs

#

Alr, ordered

uncut rock
obtuse jolt
#

should be pretty straightforward

#

be safe around the psu wires tho

#

unplug and let the caps discharge

uncut rock
#

Came stripped :/

obtuse jolt
#

if its a hex socket you could try using torx bits

#

if you angle it right it should bite enough to remove it

uncut rock