Some print artefacts

[verbal thicket]

Having some print artefacs on the corners, I already change my nozzle, adjust PA and extrusion multiplier

[full tinsel]

AI Help

It sounds like you've already tried some common solutions to reduce artifacts on the corners of your prints. If you're still experiencing issues, you may want to check your bed leveling, ensure that the belts are correctly tensioned, and double-check your print speed settings. Additionally, experimenting with temperature settings could help improve the issue.

WARNING: This response is AI generated and may contain errors.

[pine vine]

i've seen similar artifacts with orcaslicer/bambu studio's slow down for overhangs setting on. i almost always turn it off unless i have specific need, personally. YMMV.

[verbal thicket]

Thats not on overhangs, its like a PA problem, the amount of filament extruded seems not enough

[pine vine]

Okay.