#V0.2 VFAs in all directions

1 messages · Page 1 of 1 (latest)

nimble skiff
#

Seems to occur in all sides even with a square printed at a 45 angle. The VFAs are separated by a 1mm gap.

Speed has little to no effect same with belt tension.

This is a formbot V0.2 kit.

IMG_6039.jpg IMG_6040.jpg
edgy narwhalBOT
#
AI Help

It sounds like you are experiencing issues with your 3D print quality, specifically with inconsistent layers or gaps across your print. Here are some troubleshooting steps you can try:

  1. Check your nozzle: Make sure your nozzle is clean and free from any clogs or debris. You may need to do a cold pull to clean out the nozzle.

  2. Calibrate your extruder: Ensure that your extruder steps/mm are properly calibrated. This can help ensure that the correct amount of filament is being extruded.

  3. Check your filament: Make sure your filament is dry and free from moisture, as this can cause issues with the print quality. You can try drying out your filament in an oven at a low temperature.

  4. Check your cooling: Insufficient cooling can cause issues with overhangs and details. Make sure your cooling fan is working properly and is cooling the print effectively.

  5. Check your slicer settings: Review your slicing settings, such as layer height, print speed, and tempera...

WARNING: This response is AI generated and may contain errors.