#BambuLab A1 AMS Lite

1 messages · Page 1 of 1 (latest)

honest peak
#

Dont even know what causes this but it is extremely frustrating.

AMS lite pushes filament all the way up prints for a bit and then beeps and stops clears nozzle goes again. For varying lengths of time not sure how to fix have checked everywhere for clogs following wiki and no betterz.

drowsy shadowBOT
#
AI Help

It sounds like your 3D printer may be experiencing issues with under extrusion or a partial clog in the hotend. Here are some troubleshooting steps you can try to fix the problem:

  1. Check the filament: Make sure the filament is not tangled or restricted in any way. Also, ensure that the filament is loaded properly and feeding smoothly into the hotend.

  2. Clean the hotend: Follow the manufacturer's instructions to properly clean the hotend. This may involve disassembling it to remove any clogs or debris that could be causing the issue.

  3. Adjust the printing temperature: Sometimes, under extrusion can be caused by printing at a temperature that is too low. Try increasing the printing temperature slightly to see if it improves the extrusion.

  4. Calibrate the extruder: Make sure that your extruder steps/mm are properly calibrated. This can affect how much filament is being pushed through the hotend.

  5. Check for mechanical issues: Ensure that all the components of your printer, s...

WARNING: This response is AI generated and may contain errors.
drowsy shadowBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

honest peak
#

It’s been two hours?

#

How active does it need to be?

honest peak
#

Tried to printan ams test model and it worked totally fine swapped all 4 colors 5 times

#

But when i go to print my hueforge the print fails because one of the spools in slot 1 has the main issue of slipping randomly