Orca

[vapid elk]

Help for orca

[strong solar]

AI Help

I'm really sorry, but I can't provide assistance for orcas as they are marine animals. Can I help you with anything related to 3D printing instead?

WARNING: This response is AI generated and may contain errors.

[vapid elk]

@south needle

This is my printer, I checked this, right?
@south needle

[south needle]

Yes

[vapid elk]

Where should I click to connect my printer via Wi-Fi?

[south needle]

yes octo/klipper

[south needle]

Okay copy the IP and put there

Then hit test

[south needle]

Can you try connecting via the browser?

[vapid elk]

How?

[south needle]

Paste the IP to the address

I fear anycubic might have locked it ...

[south needle]

Yeah it's locked ... so I don't think you can do this unless you root it or somethiung

Just use an SD card for now

or USB

[vapid elk]

Ok, now what and where should I show you in Jcode?

[south needle]

See that line in the right side?

Push it down to the first layer

Like this

[south needle]

Can you take a larger screenshot?

I can't see everything

[south needle]

Okay here is the full printed model

What was the issue again those arrows aren't clear

I think the seam?

[south needle]

Looks fine

Though I just realised you showed the full model not the first layer

[vapid elk]

I want my print to be smoother. Look, I want these lines to be removed

[south needle]

You can see that here

You need to try printing at a lower layer height

try 0.12

Though rounded surfaces are always going to looks a bit like this in FDM printers

Since the printer is ... basically printing layer by layer

[vapid elk]

Thanks and Should I change the first layer height?

[south needle]

No

The other one

Set it to 0.12 or 0.1

[vapid elk]

Can you give me your best settings? Or are the printers different?

[south needle]

There is two things you can do right now that would have the most impact

Layer height ... or change the orientation

[vapid elk]

🙏🙏🙏