Anycubic photon mono 7 pro leveling

[dense crater]

Anycubic mono 7 pro is pain of my existence i printed 11 tests 1 came out good every other either half is stuck to the bottom or whole thing is stuck to the bottom Notting on plate i Tried manual leveling 5 times now, I printed r.e.r.f test and the ones on the upper left and right edge printed fine one on the right printed fine but bottom ones and middle were stuck to the fep, leveling? Bottom layers ? What is the problem

[raw sinew]

AI Help

It sounds like you are experiencing adhesion issues with your AnyCubic Mono 7 Pro resin printer. Here are a few troubleshooting steps you can try:

1. Check the leveling of your build plate again. Make sure it is perfectly leveled by adjusting the screws in small increments.

2. Increase the exposure time for the bottom layers in your slicer software. This will help improve adhesion to the build plate.

3. Try using a different type of resin with improved adhesion properties.

4. Make sure your FEP film is properly installed and clean. A damaged or dirty FEP film can cause adhesion issues.

5. Check the curing settings for your resin. Ensure that you are using the correct exposure time and curing settings recommended by the resin manufacturer.

If these steps do not improve your prints, you may need to contact AnyCubic's customer support for further assistance.

WARNING: This response is AI generated and may contain errors.

[wicked steppe]

eee wxposure time resin temp

1st layer exposure time

etc

[dense crater]

Room temp 20C heater is set up to 30C so no way in hell it's temperature

[fossil summit]

Best to ask in #✅｜help-resin