#Stepping motor/calibrating problem ?

1 messages · Page 1 of 1 (latest)

ember quartz
#

Hello guys, can someone please help me with this problem ? I just turned on the printer to print something and it start to do this, i also tried factory reset but nothing… Printer : Ender 3 V3 KE

slow oasisBOT
#
AI Help

It sounds like you may be experiencing a hardware issue with your Ender 3 V3 3D printer. The behavior you described could be caused by a variety of factors such as a loose connection, faulty motor, or incorrectly calibrated settings. Here are some troubleshooting steps you can try:

  1. Check all cable connections to ensure they are securely plugged in.
  2. Verify that the stepper motor drivers are properly seated and functioning correctly.
  3. Recalibrate your printer settings, such as the bed leveling and nozzle height.
  4. Ensure that the filament is loaded correctly and not tangled.
  5. Check if there are any firmware updates available for your printer.

If these steps don't resolve the issue, you may need to contact the manufacturer for further assistance or consider seeking help from a professional technician.

WARNING: This response is AI generated and may contain errors.
terse rune
#

i would check all motor connections

#

see if something got loose

ember quartz
#

all cables are connected properly

terse rune
#

try disconnecting the x-axis stepper motor

#

and home the y axis

ember quartz
#

cannot rlly do that, i factory reset it and can't do the setup because of this problem...

terse rune
#

does it force you to do the setup?

ember quartz
#

i was about to say it is stuck here

terse rune
ember quartz
#

but actually looks like it is working again.. i wait to see if it complete the setup

#

i did the same thing 10 times minimum

terse rune
#

sometimes they'll be like that🤷‍♀️

ember quartz
#

gosh

#

i hope is good now, i will come back with news

#

nope... Same thing.. buzzing motor and not centered :((

terse rune
#

try cleaning the motion system