#Sv06 plus worst layer shift i ve seen

1 messages · Page 1 of 1 (latest)

gentle wedge
#

how do i fix this realyy really bad layer shift
ive tried to print a vase nbut this layer shift happens to everthing

20241117_170644.jpg
wide graniteBOT
#
AI Help

Layer shifting can occur due to various reasons, such as loose belts, obstructions in the movement of the printhead, or overheating of the stepper motors. Here are some troubleshooting steps you can try to fix layer shifting:

  1. Check the belts: Make sure the belts are properly tensioned and not slipping during the print. Tighten them if necessary.

  2. Lubricate moving parts: Ensure that all the moving parts, such as rods and rails, are well-lubricated to enable smooth movement.

  3. Check for obstructions: Make sure there are no obstructions that could be hindering the movement of the printhead or the print bed.

  4. Check motor temperature: If the stepper motors are overheating, try reducing the print speed or adding cooling fans to prevent them from getting too hot.

  5. Check motor drivers: If the stepper motor drivers are faulty, they may cause erratic movements. Consider checking and potentially replacing them if needed.

If the issue persists after trying these solutions, you m...

WARNING: This response is AI generated and may contain errors.
wide graniteBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

gentle wedge
#

no one helps 😦

real harness
#

What's your speed and acceleration? And also check the belt tension for both x and y axis