Corner artifacts

[sharp geyser]

Not sure what's causing this as all other kinda of prints work just fine. Any time I print a gridfinity bin or something similar with a curved edge, I got these issues along the edge. White and black are PETG, blue is PLA. Could my belts be loose or maybe I'm printing too fast? Using a Qidi X Plus 3 at stock profiles. Anyone have any ideas?

[green coyote]

AI Help

It looks like you're experiencing some layer inconsistencies or ringing artifacts along the curved edges of your prints. This could be a result of various factors, including loose belts, acceleration settings, or even cooling issues. Here are some troubleshooting steps you can try:

1. Check your belt tension: Make sure that the belts on your printer are properly tensioned. Loose belts can cause inaccuracies in the print due to backlash.

2. Adjust acceleration settings: Lowering the acceleration settings in your slicer software can help reduce ringing artifacts on your prints.

3. Optimize cooling: Ensure that your cooling fan is working properly and adjust the cooling settings in your slicer to prevent overheating and improve print quality.

4. Check print speeds: Printing too fast can also result in ringing artifacts. Try lowering the print speed to see if it improves the quality of your prints.

5. Consider using a smaller layer height: Using a smaller layer height can help impr...

WARNING: This response is AI generated and may contain errors.

[proud pecan]

Try calibrating pressure advance

[green coyote]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.