What's happening here and how can I fix it? | 3D Printing | Page 1

lofty seal Nov 11, 2024, 3:54 PM

#

I was using Creatily Slicer and switched to Cura, now my printer isn't printing consistently.

weary creekBOT Nov 11, 2024, 3:54 PM

#

lofty seal I was using Creatily Slicer and switched to Cura, now my printer isn't printing ...

#

AI Help

Switching slicing software can sometimes lead to inconsistencies in printing due to differences in settings and profiles. I recommend checking that your printer settings in Cura match what you were using in Creatily Slicer, including layer height, print speed, temperature, and cooling. Additionally, ensure that your filament diameter is correctly set in Cura. It may take some experimentation to fine-tune your settings for optimal results.

uneven sedge Nov 11, 2024, 4:07 PM

#

@lofty seal your bed isnt leveled on the left side

#

the right side looks well

#

the bottom left looks very high from the picture

lofty seal Nov 11, 2024, 4:08 PM

#

uneven sedge <@1145892465103089794> your bed isnt leveled on the left side

That's what I thought but that line the printer starts with looks fine

uneven sedge Nov 11, 2024, 4:09 PM

#

try leveling all sides over again and measure a good z off set and see if it still happens

lofty seal Nov 11, 2024, 4:10 PM

#

I'll give that a shot

uneven sedge Nov 11, 2024, 4:10 PM

#

👍

lofty seal Nov 11, 2024, 5:07 PM

#

@uneven sedge Thanks the prints are turning out great now!

uneven sedge Nov 11, 2024, 5:08 PM

#

lofty seal <@659166266711605249> Thanks the prints are turning out great now!

your welcome

#

?solved

#What's happening here and how can I fix it?