#LotMaxx printer: Cura slices can't be printed (finishes instantly?)

1 messages · Page 1 of 1 (latest)

normal dome
#

Hi so i got the LotMaxx SC10-Shark and so far i've made it through a lot of configuration and everything is fine now, but when i slice something with Cura instead of the LotMaxx slicer, the printing process starts at a 100% and finishes instantly. I've sliced the same file with Cura 5.3.1, 5.8 and the current LotMaxx version and only the LotMaxx Version is working?

Does someone know what could be the problem? 🤔 The problem that arises from this is while LotMaxx slicer is working on my PC, it is not working on my laptop nor my girlfriends laptop (but Cura does work on every machine)

tacit irisBOT
#
AI Help

It sounds like there may be an issue with the G-code generated by Cura not being fully compatible with your LotMaxx SC10-Shark. Try checking the G-code settings in Cura to ensure they match the settings used in the LotMaxx slicer. Pay close attention to things like print speeds, temperatures, and other printing parameters.

If the issue persists, you may want to try using a different slicer software that is known to work well with your specific 3D printer model. Alternatively, reaching out to the manufacturer or the 3D printing community for support and guidance could also help you troubleshoot the issue further.

It's also important to note that using the manufacturer's provided slicer software can sometimes yield the best results as it is tailored to work seamlessly with your specific printer model.

WARNING: This response is AI generated and may contain errors.
tacit irisBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

normal dome
#

reopen pls

plain raptor
#

Thats just an ender 3 clone, isn't it?

normal dome
#

Looks Like

#

What about the start Gcode? Im new

plain raptor
tacit irisBOT
plain raptor
#

The start gcode is the first few lines that set up the printer for printing. Its defined in the slicer profile. Your printer has a two in one out hotend?

normal dome
#

Yes but i only use one

trail prawn
#

Try using a different model and see if that works. Also can you send the GCODE you are using?

normal dome
#

I can do that, I sliced the stl with the Lotmaxx slicer and it worked

tacit irisBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

normal dome