slice keeps failing | 3D Printing | Page 1

ivory mirageBOT Oct 28, 2024, 4:06 AM

#

AI Help

It sounds like your print may be experiencing adhesion issues. Here are a few suggestions to improve bed adhesion and prevent the print from coming loose:

Ensure your print bed is leveled properly. Use a piece of paper to check the distance between the nozzle and the bed at different points on the bed surface.
Increase the bed temperature. Some filaments require higher bed temperatures for better adhesion.
Try using a brim or raft in your slicing software to provide a larger surface area for the first layer to adhere to.
Look into using a specialized bed adhesive such as glue stick, hairspray, or a PEI sheet to improve adhesion.
If the issue persists, consider using a different filament type that may have better adhesion properties for your specific print.

Experiment with these suggestions to see if they improve the adhesion of your print and prevent it from coming loose.

uneven crane Oct 28, 2024, 4:07 AM

#

suck it up

rare flume Oct 28, 2024, 4:07 AM

#

send an image

#

we also don't know what printer it is

tawny terrace Oct 28, 2024, 4:10 AM

#

rare flume send an image

#

oh my bad, its a ender 3 v2

rare flume Oct 28, 2024, 4:13 AM

#

Try brimming

#

but reclean your bed

#

I recommend using dish soap and running water like those in a sink

tawny terrace Oct 28, 2024, 4:14 AM

#

whats brimming?

rare flume Oct 28, 2024, 4:14 AM

#

check your slicer

tawny terrace Oct 28, 2024, 4:14 AM

#

and sure i'll reclean it

deep sierra Oct 28, 2024, 4:15 AM

#

Adding a brim will add additional material around the perimeter

rare flume Oct 28, 2024, 4:15 AM

#

deep sierra Oct 28, 2024, 4:15 AM

#

uneven crane suck it up

We stay nice and constructive, right?

rare flume Oct 28, 2024, 4:15 AM

#

this is a brim, it increases the surface area the print is holding on the plate

uneven crane Oct 28, 2024, 4:16 AM

#

deep sierra We stay nice and constructive, right?

of course of course

tawny terrace Oct 28, 2024, 4:18 AM

#

i can give that a try, for sure

ivory mirageBOT Oct 28, 2024, 6:20 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

soft latch Oct 28, 2024, 11:38 AM

#

tawny terrace

it is ofc bed leveling but i dont know if your printer has auto bed leveling and if it does try to level the bed your self

ivory mirageBOT Oct 28, 2024, 1:40 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

#slice keeps failing