Accelerometer on cr10 v3

[karmic lantern]

I have a couple bed slinger machines I was looking at migrating to klipper and configuring input shaping. I seen that you need a accelerometer on the hot end mount, as well as the bed.. problem ive seen with the bed mounts its they usually will go over or on top of the pei plate. Does anyone know of or use a mount that mounts under the bed?

[knotty smelt]

AI Help

I am not sure of any specific mounts that fit your exact criteria, but you could consider designing a custom mount that fits underneath the bed to accommodate the positioning requirements for the accelerometer. Alternatively, you could reach out to online forums or communities dedicated to 3D printing for suggestions and potential solutions from experienced users.

WARNING: This response is AI generated and may contain errors.