#Bambu A1 Stringing

1 messages · Page 1 of 1 (latest)

honest river
#

So I did among my first prints a hogwarts. But a ton of stringing seems to have occuried. Im new to using a bambu so how do I fix this? The filament is recently dried so its not wet.

462549885_8893563874029830_1140713910198294323_n.png
weary bronzeBOT
#
AI Help

To fix stringing in your print, you can try the following steps:

  1. Check your retraction settings. Increase the retraction distance and speed in your slicer settings to reduce stringing.
  2. Adjust the printing temperature. Lowering the temperature slightly can help reduce stringing.
  3. Increase travel speed. Faster travel moves between print areas can help minimize stringing.
  4. Calibrate your extruder. Ensure that the filament is extruding at the correct rate to prevent excess material from oozing out.

Since you mentioned using bamboo filament, make sure your printer is compatible with this material as it may require specific settings. Good luck with your Hogwarts print! If you have more questions, feel free to ask.

WARNING: This response is AI generated and may contain errors.
chilly stone
#

How did you dry the filament?