#Help with Visual studio code (Marlin)

1 messages · Page 1 of 1 (latest)

scenic otterBOT
#
AI Help

I can definitely help you with that! Here is a step-by-step guide to set up your BTT SKR 2 with your CR10:

  1. Download the latest Marlin firmware for your BTT SKR 2 board from the official Marlin website.
  2. Install the Arduino IDE on your computer if you don't already have it.
  3. Connect your BTT SKR 2 board to your computer using a USB cable.
  4. Open the Marlin firmware in the Arduino IDE.
  5. Configure the firmware settings according to your CR10 and BTT SKR 2 board specifications. This includes settings such as printer type, bed size, thermistors, stepper motor drivers, and endstops.
  6. Compile and upload the firmware to your BTT SKR 2 board.
  7. Once the firmware is successfully uploaded, your CR10 should be ready to print again.

If you encounter any issues during the process, feel free to ask for help. Happy printing!

WARNING: This response is AI generated and may contain errors.
ionic remnant
#

basically what the bot said but exchange Arduino IDE for VSC

#

https://www.youtube.com/watch?v=1PPBHn-jU0k

YouTube
Chris Riley
Big Tree Tech SKR 2 - Install - Marlin Configuration - Chris's Base...

We're back.......
We're back with Big Tree Tech's SKR 2 mainboard. Today we discuss some of the problems BTT had with the SKR 2, do a deep dive into past boards along with a step by step install and configuration.

00:00 Introduction
02:05 Good Board / Bad Board
03:51 SKR Comparison
08:06 SKR 2 Features
10:28 Driver Install
14:16 Board Install
...

▶ Play video
#

this will help

left wharf
#

23:10 mark where he changes the temps and stuff

ionic remnant
left wharf
#

check the video and the timestamp above its got something to do with thermistor settings

ionic remnant
#

check what thermistor you have and choose the thermistor from the table

#

99% you have a 1, a normal 100k thermistor

left wharf
#

"from the table" i dont know what that means monkakarp

ionic remnant
#

this one, right?

#

from line 457 to 556

left wharf
#

i downloaded from the site

#

im using the stock thermistor

#

so im just putting it at 1 as you said

ionic remnant
left wharf
#

cr10

ionic remnant
#

if you have temp problems try nr 5

#

best you check before though

left wharf
#

ookay