Under extrusion on start of layer | 3D Printing | Page 1

turbid spire Oct 19, 2024, 4:11 PM

#

What is going on on his nose part you see there is like holes(underextrusion after retraction) why is that happening,
There is no oozed filament and retraction is 3mm and 30mm/s printing at 120mm/s speed

agile valeBOT Oct 19, 2024, 4:11 PM

#

turbid spire What is going on on his nose part you see there is like holes(underextrusion aft...

#

AI Help

It sounds like you might be experiencing underextrusion after retraction which can result in gaps or holes in your print. This issue could be caused by a few factors such as incorrect retraction settings, clogs in the nozzle, inconsistent filament diameter, or printing speeds that are too high.

Start by checking and adjusting your retraction settings, make sure your nozzle is clean and not clogged, calibrate your extruder steps/mm, and decrease your print speed to see if that helps reduce the issue. Also, consider adjusting your temperature settings and ensuring that your filament diameter is consistent.

agile valeBOT Oct 19, 2024, 6:16 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

turbid spire Oct 19, 2024, 6:54 PM

#

Anyone knows or had same issue?

#Under extrusion on start of layer