#Print keeps failing (Printer: Ender v3 se, Print: Easy 13)

1 messages · Page 1 of 1 (latest)

unborn inlet
#

So I'm trying to print an Easy 13 (https://www.printables.com/model/555170-easy-13-printable-jointed-figure/files), specifically the plated joints part, but the print just keeps on failing.

I've attempted the print about 5 times now, and no matter what it keeps failing. usually most of prints fine expect for the bottom right corner of the model, which I think isn't sticking to the bed. One time the whole model actually didn't stick and I got a massive clog so that kind of sucked.

Printer: Ender V3 SE, no modifications
Model: Easy 13, parts-joints v24.stl
Filament: TINMORRY 1.75 PLA
Slicer: Cura
Gcode and model are attached.

IMG_20241019_140724.jpg
Printables.com
EASY 13 Printable Jointed Figure by soozafone | Download free STL m...

The classic Lucky 13 figure, overhauled from the ground up for easier printing and assembly! | Download free 3D printable STL models

raw basinBOT
#
AI Help

It sounds like you may be dealing with adhesion issues on your print bed, specifically in the bottom right corner of the model. Here are a few troubleshooting suggestions:

  1. Bed Leveling: Make sure your print bed is leveled correctly. Even a slight tilt can cause adhesion issues. Use a piece of paper to check the distance between the nozzle and the bed at all four corners and adjust as needed.

  2. Bed Surface Preparation: Ensure that your print bed surface is clean and free of any debris or oils. Consider using adhesion aids such as glue stick, hairspray, or specialized bed adhesion sheets to help the first layer stick better.

  3. First Layer Settings: In Cura, make sure your first layer settings are optimized. You may need to increase the first layer bed temperature, adjust the initial layer height, or slow down the printing speed for the first layer to improve adhesion.

  4. Filament Flow: Check for any potential clogs or issues with filament flow by ensuring the ...

WARNING: This response is AI generated and may contain errors.
unborn inlet
unborn inlet
# raw basin
  1. Bed was auto levelled before each attempt
  2. I cleaned the build plate with hot soap and water recently, and i have a textured build plate
  3. idk anything about this
  4. There wasnt any clog issues
raw basinBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

unborn inlet
#

anyone have any idea on what might be the problem? all help is appreciated

pastel jetty
#

@unborn inlet first of all, nice you found a poseable model,second of all, clean your bedplate with dish soap and run it through the sink

#

if it still didnt stick, use a brim