New 3d printer here, wanted some advice for this project | 3D Printing | Page 1

viscid hill Oct 15, 2024, 4:17 PM

#

Hey everyone, I wanted to print this 3d model I made, and I wanted to know if its safe to make with Infill: 0%, Material: PLA - White, Resolution: 0.20mm, Dimensions: 12.0719 × 12.8718 × 16.0011 cm. I wanted to know if the infill will cause any problem or the resolution wont make the letter readable since the dimensions are not that high. Thank you!!

green oxideBOT Oct 15, 2024, 4:17 PM

#

viscid hill Hey everyone, I wanted to print this 3d model I made, and I wanted to know if it...

#

AI Help

Thank you for reaching out with your question. With 0% infill, the model will be hollow, which might affect its structural integrity depending on the design. Keep in mind that increasing infill can provide more support and sturdiness to the print. As for the resolution, printing at 0.20mm should be fine for most text to be readable, but finer details might not come out as sharp. It's always a good idea to do a test print to see how the final result looks. Good luck with your project!

faint rock Oct 15, 2024, 4:18 PM

#

No

#

No infill will maje this unstable

viscid hill Oct 15, 2024, 4:19 PM

#

faint rock No infill will maje this unstable

ohhh i see, so 20% infill is that enough?

faint rock Oct 15, 2024, 4:22 PM

#

10 to 20 should be enough, you need some supports for the horn of the grammophone

viscid hill Oct 15, 2024, 4:23 PM

#

ok ok, thank you very much for the fast reply!!

faint rock Oct 15, 2024, 4:33 PM

#

Use tree supports on buildplate only to save you some cleanup

green oxideBOT Oct 15, 2024, 6:38 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

north bridge Oct 15, 2024, 11:14 PM

#

Yeah 0 infill will kill it for sure

#New 3d printer here, wanted some advice for this project