linear rail issues | 3D Printing | Page 1

pliant mason Oct 10, 2024, 10:11 PM

#

Lin rail swapping e3v2 hasn't given me the performance I've been looking for and I think it's due to a issue when tightening the parts of the linear rail setup

wide grailBOT Oct 10, 2024, 10:11 PM

#

pliant mason Lin rail swapping e3v2 hasn't given me the performance I've been looking for and...

#

AI Help

It sounds like you may be experiencing issues with the assembly of your linear rail on your Ender 3v2 3D printer. Make sure you are correctly tightening all parts of the linear rail setup according to the manufacturer's instructions. Over-tightening can cause binding or misalignment. Double-check your assembly and refer to the printer's manual for guidance.

pliant mason Oct 10, 2024, 10:11 PM

#

I have aligned the linear rails to the extrusion and they run smooth with no other parts on them

#

But when I tighten the mounting hardware it becomes much more stiff

#

Both loose

#

Both tight

#

Close loose, far tight

#

This issue gets even worse after mounting the bed frame

#linear rail issues