help me got this out | 3D Printing | Page 1

vagrant copper · 2024-10-03T19:09:11.755Z

So this is stuck and i got no idea how to get it out, tried heating pushing with stick i got no idea, i think i got all screws lose aswell its a ender 3v3 SE

AI Help

It sounds like you're experiencing a filament jam in your Ender 3 V2 SE 3D printer. Here are some steps you can try to clear the jam:

Heat up the hotend to the printing temperature of the filament that is stuck.
With the nozzle at temperature, try gently pushing a small piece of filament through the nozzle by hand. Sometimes this can help clear the clog.
If the filament isn't moving, you can try using a cleaning filament or a thin piece of wire to manually clear the blockage. Be very careful not to damage the nozzle.
If the above steps don't work, you may need to partially disassemble the hotend to access the clog. Make sure the printer is turned off and cool before attempting this.

If you're still having trouble, it may be helpful to reach out to the manufacturer or a local 3D printing community for further assistance.

#help me got this out