Weird gaps only on left side of print

[wild ingot]

What could be causing these weird gaps that are ONLY on the left side of the prints? (other sides are fine)
What i already tried:
Changing the pressure advance and even turning it off
Changing the retractions
Lowering the speeds and accelerations (lowering the speeds made it even worse)
Changing the print temp (210, 220, 230)

[silver rover]

AI Help

It sounds like you may be experiencing issues with your printer's belt tension or alignment, or possibly a partially clogged extruder on the left side. I recommend checking the belt tension and alignment, ensuring that they are properly adjusted. Additionally, try cleaning the extruder on the left side and checking for any clogs that may be causing inconsistent extrusion. You may also want to check the nozzle and make sure it is not partially blocked on the left side. If the issue persists, you may need to calibrate your printer or possibly look into other hardware issues that could be causing the gaps.

WARNING: This response is AI generated and may contain errors.