Just thermal pasted the heatbrake and this popped up while the printer had a beeping seizure:

[plain sail]

Recv: X:150.00 Y:120.00 Z:11.25 E:0.00 Count X:12000 Y:9600 Z:4500
Recv: ok
Send: M113 S2
Recv: ok
Recv: T:-15.00 /0.00 B:30.28 /0.00 @:0 B@:0
Recv: T:-15.00 /0.00 B:30.21 /0.00 @:0 B@:0
Changing monitoring state from "Operational" to "Starting"
Send: N0 M110 N0125
Recv: ok
Changing monitoring state from "Starting" to "Printing"
Send: N1 M104 S200102
Recv: ok
Send: N2 M10537
Recv: T:-15.00 /200.00 B:30.21 /0.00 @:0 B@:0
Recv: ok T:-15.00 /200.00 B:30.21 /0.00 @:0 B@:0
Send: N3 M109 S200105
Recv: T:-15.00 /200.00 B:30.21 /0.00 @:0 B@:0 W:?
Recv: Error:MINTEMP triggered, system stopped! Heater_ID: E0
Recv:
Changing monitoring state from "Printing" to "Error"

[compact flame]

AI Help

It seems like your 3D printer has encountered a MINTEMP error, which means that the printer's firmware has detected that the temperature of the hotend (heater E0) is below the configured threshold. This can happen due to issues such as a disconnected or faulty thermistor, a loose connection, or a malfunctioning heating element.

Here are some steps you can take to troubleshoot and resolve the MINTEMP error:

1. Check the connections: Ensure that the thermistor and heater cartridge connections to the control board are secure and not loose. If any connections are loose or disconnected, reconnect them properly.

2. Inspect the thermistor: The thermistor may be faulty or damaged. Check the thermistor for any signs of physical damage and ensure it is properly positioned and making good contact with the hotend.

3. Test the thermistor: You can use a multimeter to test the resistance of the thermistor. Compare the resistance readings with the expected values for your specific thermistor mo...

WARNING: This response is AI generated and may contain errors.