#cura walls printing slower at specifig height

1 messages · Page 1 of 1 (latest)

tender tendon
#

i have printed the models in the picture. However, I noticed that the speed of the walls of the middle model decreases significantly as soon as the other two on the right and left have been printed. However, the speed of the walls is 60mm/s and it still slows down.

image.png
opal spearBOT
#
AI Help

It sounds like you may be experiencing issues with cooling and layer adhesion. As the other models are printing, they may be affecting the cooling on the middle model, causing it to slow down as the layers aren't able to cool sufficiently.

You could try adjusting the cooling settings in your slicer software to increase the fan speed or decrease the minimum layer time to improve cooling. Additionally, make sure your printer's hotend and heat block are properly insulated to maintain consistent heat flow.

Also, check your filament temperature and ensure it's within the recommended range for your filament type, as printing too hot can also lead to cooling issues. If the problem persists, consider printing a cooling tower alongside your models to help regulate temperature across the print bed.

WARNING: This response is AI generated and may contain errors.
celest pumice
#

Probably related to minimum layer time, the print will slow down to meet the required time to print each layer

tender tendon
#

How can I change that?

fresh tartan
fresh tartan
tender tendon
#

I will try that! THanky you 😄 !!!