#Can someone help me mod my printer.cfg in clipper?

1 messages · Page 1 of 1 (latest)

near tiger
#

I need to make my printer print 15mm to the right. It is printing 15mm off center which makes big prints impossible, I have an ender 3 v2 neo with a build plate of 235mmx235mmx250mm.

delicate ironBOT
#
AI Help

To adjust the print position on your Ender 3 V2, you can modify the G-code to shift the print in the desired direction. You would need to add an offset in the slicer software or directly in the G-code itself. For a 15mm shift to the right, you could incorporate a G-code command like G92 X250 to reset the extruder position. Additionally, you could adjust the bed size in your slicer to accurately reflect the actual print area. Be mindful of the printer's limits and ensure that the modifications do not surpass the physical constraints of the printer.

WARNING: This response is AI generated and may contain errors.
near tiger
#

Here is my printer.cfg ^

delicate ironBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

near tiger
near tiger
delicate ironBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

near tiger
#

^

near tiger
#

^

near tiger
#

Help

near tiger
#

Help

near tiger
#

Help

near tiger
#

Help

near tiger
#

Nvm i did it by myself with some research

delicate ironBOT
#

Is your problem solved? / No longer need this channel?
You can close a help channel with ?solved when it is no longer needed.

?close requested by: m.von.d#0