How to level sovol sv06 plus with it stuck too low?

[worthy pagoda]

So, i've recently had multiple successful prints. When it came to this print, I tried removing some leaking petg from the nozzle before it the print started. I missed the nozzle, so i paused the print, and tried to increase the z-level to get to the nozzle. So I stopped the print altogether, and now every time I click autohome it goes too low and slams into the bed and an infinite loop in the software now knowing where it is.

How can I get to save the leveled z-level without auto-homing?

[ripe wadi]

AI Help

It sounds like your printer's Z-axis needs to be properly leveled. To do this without auto-homing, you can manually adjust the Z-axis using the controls on your printer or through the printer's software interface.

First, make sure the printer is turned off to avoid any accidental movements. Then, manually move the Z-axis up slightly using the controls until you have enough space to access the nozzle without it hitting the bed. Secure the Z-axis in place, and then turn on the printer and adjust the Z-offset in the settings to save the new level.

It's important to be cautious and precise when manually adjusting the Z-axis, as incorrect adjustments can affect print quality and potentially damage the printer.

WARNING: This response is AI generated and may contain errors.

[worthy pagoda]

Yeah, this AI help isn't helpful at all, as I can't get to the option on the sv06 plus's to change/save the z-offset. This is the real issue.

[ripe wadi]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[rich dagger]

how about factory resetting it?

it uses the induction probe right? it should sense the metalic bed. and not crash into it. its ignoring it and crashing anyway? even if it doesnt know XY it still shouldnt crash Z