Ender 3 pro prints the skirt just fine and then stops when it comes to the actual piece | 3D Printing | Page 1

fringe sable Aug 22, 2024, 10:52 AM

#

The temperatures looks good, the nozzle is fine, bed leveled, i start the print and it prints the skirt just fine but then boom stop printing when it goes to the middle to stop the actual piece to print

tiny vesselBOT Aug 22, 2024, 10:52 AM

#

fringe sable The temperatures looks good, the nozzle is fine, bed leveled, i start the print ...

#

AI Help

It sounds like you may be experiencing a problem with the model or the print job itself. Check the slicing software to ensure the model is not corrupted or missing layers in the problematic area. Additionally, double-check the G-code file and make sure there are no errors in the code around the location where the print stops. If the issue persists, try re-slicing the model and reprinting to see if the problem is resolved.

fringe sable Aug 22, 2024, 10:55 AM

#

printer is a ender 3 pro, only mod is alluminum extruder, firmware is 1.1.6.2, pla at 215 and 55 bed, the recommended is 210-230 and 45-60

#Ender 3 pro prints the skirt just fine and then stops when it comes to the actual piece