extruder not bringing filament out mid print (happened 3 times)

[wet osprey]

I was printing something and filament just stopped coming out

[quasi moat]

AI Help

It sounds like you may have a clog in your nozzle. Try using a nozzle cleaning kit to remove any obstructions. You can also try adjusting your retraction settings to prevent future clogs.

WARNING: This response is AI generated and may contain errors.

[quasi moat]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[solemn topaz]

Hm, clikcing extruder?

Or is nozzle jammed?

[wet osprey]

Its because the yes

[solemn topaz]

So it clicks?

[feral island]

Hm

i had the same issue one time.

It’s probably jammed

It could be the hottend or the extruder, first check the hottend.

[wet osprey]

So I am having a problem with both

The print stops because the extruder slips

And then I have to readjust again

And it reaches the point where the filament is like cut in half because it was pressed on much

And sometimes there is clog in the pipe inside the extruder

I recently cut the pipe before And idk whats the correct hight to put it on(between the ed of the pipe and the screw thing)

But when everything looks fine and good to print, the extruder slips

So thats the main problem

The distance between the coupler and the nozzle, it could also be the priting temps

[wet osprey]

I just realised how hard it is to push the filament in the tube, its very hard

I don't think there is a clog too

And I cut a lot of the tube

Like even i cant push the filament in from extruder

[burnt fern]

Open up the hotend and check for jams, internal clogs, or filament that broke off inside

[quasi moat]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[wet osprey]

I did

But not there