printing issues | 3D Printing | Page 1

young plover Aug 15, 2024, 3:09 PM

#

Hey so I’ve recently cleaned out my nozzle, trimmed my boden tube and replaced the nozzle as I’ve been having really bad prints, but even after doing that I’ve noticed that there’s this issue where the first layer doesn’t seem to be fully printed out and that there are lots of gaps in each layer, I’m not sure if this is an extrusion issue or hired issue as previously the first layer would print perfectly fine before I replaced the nozzle

tardy acornBOT Aug 15, 2024, 3:09 PM

#

young plover Hey so I’ve recently cleaned out my nozzle, trimmed my boden tube and replaced t...

#

AI Help

It sounds like you may be experiencing an issue with your bed leveling or first layer height. Make sure your bed is properly leveled and the nozzle-to-bed distance is set correctly. Also, check your extrusion settings to ensure the correct amount of filament is being extruded. If you've already addressed these potential causes, you may want to check the nozzle temperature and filament type compatibility.

tardy acornBOT Aug 15, 2024, 5:10 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

young plover Aug 15, 2024, 7:17 PM

#

.

#

Update after relieving it all of the micro layer shifts have been solved but there’s still small gaps in the print

somber stream Aug 15, 2024, 8:51 PM

#

Do you use good brand filament ? As their might be inconsistency on cheap filament that can cause irregularities. Also check if your nozzle inside is clean

young plover Aug 15, 2024, 9:15 PM

#

somber stream Do you use good brand filament ? As their might be inconsistency on cheap filame...

I don’t think it’s the filament as I tested it out with different filaments as well and the results were the same and I did clean the hotend and nozzle so I’m really not too sure what is causing this

#printing issues