my prints are not slicing right

[distant fjord]

Hi y’all I’m trying to print a model in several different pieces and when I slice them they look like this I’ve tried blender manifold it makes it look weird and mesh maker only does that gag libel but shown in the picture any help thank you

[indigo mountain]

AI Help

It seems like you are facing issues with slicing your model into multiple pieces. It's important to ensure that your model is manifold and not have any errors that may cause slicing problems. I recommend using a different slicing software or checking the model for any issues using tools like Meshmixer or Netfabb. Make sure to fix any non-manifold geometry, intersecting faces, or other errors before slicing again for better results. If the issue persists, feel free to provide more details for further assistance.

WARNING: This response is AI generated and may contain errors.

[steady surge]

the top one could be the model is too thin, try turning on print thin walls in slicer settings, the bottom one is model errors, try an STl repair tool or finding another model

?stlrepair

[indigo mountain]

This service offers a free 3d model repair tools, to fix non-manifold obejcts (objects with tiny gaps or reversed faces):
https://products.aspose.app/3d/repairing/stl

[distant fjord]

Ok thank you I will try that

[indigo mountain]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[distant fjord]

I tried that and got this any other idea I can’t find another model like it to print this is just one piece of the over all model

[steady surge]

im not too well versed in model repair, try finding a guide for meshmixer or blender on it, from my experience its usualy easier to try replicating the model from scratch than repairing a STL

[distant fjord]

Ok thank you i tried both of those I’m not great at modeling it’s a model I bought

[steady surge]

request a refund then, there are a bunch of bad models uploaded that have this problem, I dont trust most of them for this reason, low effort scams

[distant fjord]

Ok would you know somewhere I could get a Ford excursion model I’m trying to print one with a interior to put on my 1/10 rc

[steady surge]

try searching yeggi and grabcad, they are my gotos

[distant fjord]

Ok I will look there