#Tiertime up mini pp3dp

1 messages · Page 1 of 1 (latest)

halcyon monolith
#

Hello I'm new to 3D print so I don't really know what I'm doing
Printed a circle with the rest abs which was in the printer, now I'm using a new one, but it doesnt print at all, it only consumes my abs

unique phoenixBOT
#
AI Help

It sounds like you may need to calibrate your printer for the new ABS filament you are using. Make sure the new filament is loaded correctly and ensure the print settings match the requirements for the new filament. It's also a good idea to check the bed leveling and nozzle height to ensure proper adhesion. If the issue persists, please provide more details so I can assist you further.

WARNING: This response is AI generated and may contain errors.
halcyon monolith
#

The slicer up studio, cura doesnt work/idk how

blazing sorrel
#

Oh YOU bought that thing from ebayvaulthah

unique phoenixBOT
#

How to get the best help!
To get the best help please provide as much of the following information as you can.

Printer
  - Make:
  - Model:
  - Any Mods:
  - Firmware: 
Filament
  - Material:
  - Brand:
  - Print Temp:
  - Bed Temp: 
Settings
  - Any relevant settings:
  - What Slicer are you using?:
Printer Health
  - Calibrated XYZ?:
  - Calibrated E steps?:
  - Calibrated Flow?: 
  - Calibrated retraction / Coasting?:
  - Have you hot tightened your nozzle?:
Any recent changes to:
  - The printer:
  - Slicer Settings:
  - Firmware: 
Troubleshooting
  - What are you trying to do?:
  - What is it not doing?:
  - What steps have you tried so far?:
?help_me requested by: m.von.d#0
unique phoenixBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

blazing sorrel