#Ender 3 noodles

1 messages · Page 1 of 1 (latest)

charred crag
#

So this went wrong again. Any ideas? Perfect print then BAM Ender 3 PLA+ 200 printing temp retraction distance 2 bed 60.

449792043_1045433130477692_88302160406292760_n.png 452491904_468398882825187_7631451433002914692_n.png
violet ironBOT
#
AI Help

It sounds like you may be experiencing issues with layer adhesion. Try increasing your printing temperature slightly to improve layer bonding. Additionally, consider adjusting your retraction distance and/or speed settings to minimize stringing and improve print quality. Make sure your bed is leveled properly to ensure good adhesion. If the issue persists, feel free to provide more details for further assistance.

WARNING: This response is AI generated and may contain errors.
steep halo
#

Does the spaghetti start at a big overhang?it kind of looks like something was closing over at the point where failure started.

Share a picture of the slicer or STL for the curved front bit?

Maybe peel away the spaghetti and show us what it looks like underneath? (Maybe after taking pictures from lots of angles first, in case there is some insight in the spaghetti).

Did you forget to offer a sacrifice to the flying spaghetti monster before you started?

charred crag
#
  1. Not sure
  2. Will do
  3. Too late as its in the bin. But it looks normal underneath. The side view seems to show whats happend best
  4. ... yes
steep halo
#

So that side was as intended until you hit the line of failure?

charred crag
#

Yeah

#

The rest looks perfect then suddenly bam

#

Fail

#

It doesnt look gradual. Just bam fail

steep halo
#

Out of curiosity, are the other uprights support structure only?

violet ironBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

charred crag