#filament was stuck

1 messages · Page 1 of 1 (latest)

edgy shard
#

So on my sovol sc01 pro mid print the filament wasn’t coming out so I stopped the print and tried pushing the filament down to see what would happen nothing came out and then I tried pulling it out and it was stuck took awhile but it came off so I cut the end of that filament tried putting it back in and nothing happened what do I do?

prisma lakeBOT
#
AI Help

It sounds like you might have a clog in your hotend. I recommend doing a cold pull to clear out any obstructions. Here's how you can do it: heat up your hotend to the normal printing temperature, then manually push the filament through. Once it's molten, quickly remove the filament and let it cool down completely. This can help clear out any debris or clogs that may be causing the issue. If that doesn't work, you may need to disassemble your hotend for a more thorough cleaning.

WARNING: This response is AI generated and may contain errors.
edgy shard
#

I did have it set to another higher heat for the print usually it’s 200 but this time it was 215 not that much more but still

prisma lakeBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

edgy shard
#

Does anyone know how to unclog it on a Sovol sv01 pro