Reading my resin town

[hot oar]

I know the pictures are not the best. So sorry if they are no help.
I’m just wanting to know that exactly to do with the problems I am seeing on my town.

1. The raft stuck to the build plate and caused it to break along with one of the buildings. It says that I should reduce the exposure of the bottom layer. Is the setting called bottom layer exposure or something like that? Do I have to change anything else if I change that?

2. Minimum Height of the Opening spot has the smallest 2 closed so that says to reduce exposure. What is that setting called that I need to change?

I mainly need to know what settings it is talking about and how much I should adjust them before trying it out. I know it’s trial and error I just want a starting point.

Thanks for any help!

Town link- https://ameralabs.com/blog/town-calibration-part/

[jagged crater]

AI Help

1. The setting you are looking for is usually called "Bottom Layer Exposure Time" or something similar in your slicer software. You might also want to adjust settings related to first layer adhesion and build plate temperature to help prevent the raft from sticking too much.

2. The setting for the Minimum Height of the Opening spot with the smallest 2 closed is likely related to the "Exposure Time" setting in your slicer. You can try reducing this setting to see if it helps with the issue you are experiencing.

It's recommended to make small adjustments to these settings and run test prints to see the impact before making further changes. Good luck with your printing!

WARNING: This response is AI generated and may contain errors.