#extruder stepper comes out

1 messages · Page 1 of 1 (latest)

carmine latch
#

Ive just replaced the extrusion Board for my printer but now when I move the Z axis, the stepper motor inside extruder moves too

kindred ravenBOT
#
AI Help

It sounds like there may be a wiring issue with your new extrusion board. Check the connections to ensure that they are correctly plugged in and that none of the wires are crossed or touching where they shouldn't be. It's also a good idea to check the wiring diagram for your specific printer to make sure everything is correctly connected. If the issue persists, you may need to contact the manufacturer for further assistance.

WARNING: This response is AI generated and may contain errors.
crisp zealot
#

SOunds like you have plugged in the wrong wires to the sockets

#

DO you know what control board is in your X1 ?

carmine latch
#

(pic coming)

crisp zealot
#

If i remeber correctly my X1 had an MIKS Gen L

crisp zealot
carmine latch
#

yeah

crisp zealot
#

I cant even understand how its possible , electrically, that the extruder works when the Z axis moves. The only thing i can siuggest is to go back and double check you have it all plugged in correctly

carmine latch
#

theres little to not be plugged in correctly

#

everything else is for heating, fans and thermistor

crisp zealot
#

do the X and Y axis respond correctly ?

carmine latch
#

yeah

crisp zealot
#

Sorry I cant help

carmine latch
#

dw

#

but i tried 3 seperate boards, and all the same problem

#

its probably software

crisp zealot
#

Have you recently flashed the main control board or something ?

#

Or changed something in your slicer

#

SOrry Im going to dinner Good luck

carmine latch
#

imma look if i have a backup

carmine latch
#

so

#

it was indeed the firmware

carmine latch
#

?solved