ugly holes on the top layer sovol sv06 klipper

[novel lily]

i already cold pulled to remove any derbis in the nozzle, (helped a bit)
raised the flow to 150% in the klipper software and made sure that the filament can roll without any tension.

[misty dune]

AI Help

It's great that you've already taken steps to address the issue. If the problem persists, you could also try cleaning the nozzle with a cold pull using a cleaning filament or nylon filament. Additionally, make sure your nozzle is properly leveled and your print bed is adequately heated. If the issue continues, you may need to adjust your printing temperature or check for any clogs in the hotend.

WARNING: This response is AI generated and may contain errors.

[sharp inlet]

R u making sure ur not printing the top layers too fast

Even then e step into flow recalibrate

[merry furnace]

?tuning

[misty dune]

https://ellis3dp.com/Print-Tuning-Guide/

[novel lily]

it worked a few weeks ago fine

[merry furnace]

thats like saying "before it burned down the house was not on fire"

[novel lily]

nvm