#Q1 Pro - cracking/grinding sound when moving bed down

1 messages · Page 1 of 1 (latest)

limber bobcat
#

I just unboxed this printer today, everything works fine, prints with good quality. But I noticed that in higher positions of the bed, when you move it down it makes cracking sounds. Doesn't seem like to be the bed cable scratching the back wall. Doesn't seem to affect quality, but it doesn't sound good to be normal.

proud oakBOT
#
AI Help

The cracking sounds you're experiencing when moving the bed at higher positions could be due to improper alignment or tension in the components of your printer. It's important to investigate and address this issue to prevent any potential damage in the long run. Here are some steps you can take to troubleshoot and potentially resolve the problem:

  1. Check the alignment of the bed: Make sure that the bed is properly aligned and sitting securely on its tracks. Ensure that there are no obstructions or loose components that could be causing the cracking sounds.

  2. Inspect the bed rollers: Examine the rollers that guide the movement of the bed along the tracks. Make sure that they are clean, properly lubricated, and securely attached to the bed. Replace any damaged or worn-out rollers if necessary.

  3. Adjust the tension of the bed belt: If your printer uses a belt-driven bed movement system, check the tension of the belt. A loose or overly tight belt can cause improper movement and ge...

WARNING: This response is AI generated and may contain errors.
limber bobcat
#

bruh, for some reason discord converts video into sound file