Klipper bed mesh extremely slanted | 3D Printing | Page 1

little swan Jul 11, 2024, 6:26 PM

#

Klipper on an Ender 3 V2. CR Touch, silicone spacers, G10 bed. I thought this was due to my gantry sagging at first so I took it apart and re-leveled X, but the extreme tilt toward one side and range of 1.6mm remains. If I try to use a mesh for a print that takes almost the whole bed area, I can see the Z stepper moving on the first layer but in some areas the first layer is at a perfect height and at others (the front of the bed, currently) it's so low it's digging filament into my bed. What is going on?

Captura_de_pantalla_2024-07-11_a_las_14.25.22.png

lunar furnaceBOT Jul 11, 2024, 6:26 PM

#

little swan Klipper on an Ender 3 V2. CR Touch, silicone spacers, G10 bed. I thought this wa...

#

AI Help

It sounds like you may be experiencing issues with your Z-axis alignment or your bed leveling. Check to ensure that your Z-axis is perpendicular to your bed and that all components are secure and not loose. Additionally, recalibrate your bed leveling to ensure that it is uniform across the entire bed surface. If the problem persists, consider adjusting your Z-offset in your slicer settings to compensate for variations in first layer height.

lunar furnaceBOT Jul 11, 2024, 8:28 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

little swan Jul 11, 2024, 8:29 PM

#

L

lunar furnaceBOT Jul 11, 2024, 10:33 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

little swan Jul 11, 2024, 10:34 PM

#

ok nvm then

lunar furnaceBOT Jul 12, 2024, 12:38 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

little swan Jul 12, 2024, 4:18 PM

#

Ended up just switching back to bed springs

Captura_de_pantalla_2024-07-12_a_las_12.18.01.png

warm chasm Jul 12, 2024, 5:09 PM

#

little swan Ended up just switching back to bed springs

Good that you could fix it. You compressed the silicone spacers sufficiently?

little swan Jul 12, 2024, 5:10 PM

#

¯_(ツ)_/¯

lunar furnaceBOT Jul 12, 2024, 5:38 PM

#

little swan ¯\_(ツ)_/¯

Is your problem solved? / No longer need this channel?
You can close a help channel with ?solved when it is no longer needed.

little swan Jul 12, 2024, 5:39 PM

#

?solved

#Klipper bed mesh extremely slanted