#can someone please help me flash klipper on an ender 3 s1

1 messages · Page 1 of 1 (latest)

celest inletBOT
#
AI Help

I can definitely help you with flashing Klipper firmware. Could you please provide me with more details about the issue you are facing while trying to flash Klipper?

WARNING: This response is AI generated and may contain errors.
fiery dragon
#

What guide did you follow?

#

And what have you done already

pulsar ether
#

secend, im on the part of selecting the procesor and the other things, this is the part im stuck on

fiery dragon
#

You have this config?

#

You looked up what board your printer has?

#

Well looked into the printer

#

Literally

pulsar ether
#

yes, and when i try and put the things i have to I cant, when I try to it wont let me select it

fiery dragon
pulsar ether
#

ok, give me a se

#

c

fiery dragon
# 
# S1 & S1 Pro. To use this config, check the STM32 Chip on the
# Mainboard, during "make menuconfig" select accordingly either the
# STM32F103 with "28KiB bootloader" or the STM32F401 with
# "64KiB bootloader" and serial (on USART1 PA10/PA9) for both.``` you seen this part of the config, yes?
pulsar ether
#

yes

#

and i cant find those in the option

fiery dragon
# pulsar ether

Second row, enter, choose stm. Third row, enter, choose your chip

#

Follow the docs

pulsar ether
#

thank you, i feel really stupid now

fiery dragon
pulsar ether
#

one more question, if klipper goes wrong is it posible for me to flash old firmware on it again?

fiery dragon
#

No worries

pulsar ether
#

it didnt work, it think

#

ok it didnt work

pulsar ether
#

so, I i dont know how to flash it, or it didnt work

#

yes, i followed the what it asked

#

never mind, it works now, i dont know what i did wrong the first time

celest inletBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

pulsar ether
#

?solved