lol what’s wrong w my benchy

[peak onyx]

video

[naive frigate]

AI Help

I'm here to help with questions related to 3D printing. If you have any 3D printing inquiries or need troubleshooting assistance, feel free to ask!

WARNING: This response is AI generated and may contain errors.

[peak onyx]

orca slicer

[proper ruin]

what material?

[peak onyx]

pla, normal basic everything, i think it might be because of high speeds but idk what to put it to

[proper ruin]

what speed are you printing at

[peak onyx]

and normal print speeds, 60 i think

[peak onyx]

not sure tho, if u want ill check

[proper ruin]

any way to send a video of it printing?

[peak onyx]

yes

[peak onyx]

i’ll dm u

it’ll be kinda long

[proper ruin]

@peak onyx maybe a unleveled bed?

[peak onyx]

i think maybe warped, 1 sec

[sharp jolt]

@peak onyxfirst layer is a bit too high, adjust your z-offset down. Possibly by 0.03-0.04mm. (Void under benchy).
Calibrate your retraction. (blob on the back, high retraction zone due to the text).
Your cooling seems to be inadequate. Turn up the fan or print slower. Or you are printing too hot. A temperature tower would be a good idea. (the corners of the cabin and failed bridging).
You may be printing your bridges too fast, or with not enough cooling (failed bridging).

[peak onyx]

thank you so much, also check out https://discord.com/channels/167661427862142976/1258804310184038451 there i printed a temp tower. how do i calibrate my retraction?

[sharp jolt]

@peak onyxretraction tower. There is many of them, but basically it's 2 or 4 posts with some settings to change the retraction value

[peak onyx]

also i think it could be my coolers, how do i check

[peak onyx]

ah ok

[sharp jolt]

there seems to not be much fan calibration/test out there... and very little info...

[naive frigate]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[peak onyx]

ah that sucks

[peak onyx]

yo i found this https://www.printables.com/model/58001-ultimate-fan-speed-test

[sharp jolt]

@peak onyx look nice

[peak onyx]

yea can it work w orca tho