#"printer does not accept commands" issue

1 messages · Page 1 of 1 (latest)

fickle tinsel
#

hi i´m still new to the whole 3D printing eviroment and recently my brother handed me an old LULZBOT mini. i just tried to install it in my computer but everithing went fine otherwise but when i try to print it gets interrupted before starting with a "printer does not accept commands message" i have tried to change the speed of data to a slower one and updating the firmware with no results

desert arrowBOT
#
AI Help

It sounds like you are experiencing communication issues between your computer and the LulzBot Mini. Here are a few troubleshooting steps you can try:

  1. Check the USB cable connection between your computer and the printer. Try using a different USB cable to rule out any connection issues.

  2. Ensure that the printer is correctly recognized by your computer. Check the device manager or system information on your computer to confirm that the printer is listed and recognized.

  3. Try using a different USB port on your computer. Sometimes, certain USB ports can have communication issues.

  4. Update your printer drivers on your computer. Visit the LulzBot website to download the latest drivers for the LulzBot Mini.

  5. Verify the baud rate settings on the printer and in your slicing software match. The baud rate is the speed at which the serial connection operates.

If you've already tried these steps and are still encountering issues, you may want to contact LulzBot techni...

WARNING: This response is AI generated and may contain errors.
fickle tinsel
#

im on Cura Lulzbot Ed 4.13.10 btw