clicking noise, failing prints | 3D Printing | Page 1

toxic crescent · 2024-06-30T02:52:59.130Z

I don't know much about 3d printing but I usually get by alright until I start a personal project like this. I don't know what the clicking is (in video) but I know it's not the limit switch or the nozzle scratching the print because I adjusted the offset and the clocks still continued while the offset was too high. There's also layer gaps and excess filament

AI Help

It sounds like you may be experiencing issues with your extruder. The clicking noise could be caused by the extruder motor skipping steps, potentially due to a clog or a partial blockage in the nozzle. This could also be related to the layer gaps and excess filament.

Here are a few steps you can take to troubleshoot and potentially fix the issue:

Check the filament: Make sure the filament is not tangled or stuck, and ensure it can freely unwind from the spool.
Clean the extruder: Remove any residue or clogs in the hotend and nozzle by performing a cold pull or a hotend cleaning.
Adjust the extruder tension: Make sure the extruder tension is set correctly to ensure smooth and consistent filament feed.
Check the extruder gear: It's possible that the teeth on the extruder gear are worn down, causing it to slip and create the clicking noise.
Calibrate the extruder steps/mm: Ensure that your printer is properly calibrated to extrude the correct amount of filament.

If t...

#clicking noise, failing prints