Exposed heater wires? | 3D Printing | Page 1

neon sandal Jun 28, 2024, 8:16 PM

#

I was swapping my thermistor in my Prusa mk3s+ after getting temp errors and noticed exposed wires from the heater, is this a concern?

i-was-swapping-my-thermistor-in-my-mk3s-after-getting-temp-v0-tsrz4qf9ed9d1.png

round kilnBOT Jun 28, 2024, 8:16 PM

#

neon sandal I was swapping my thermistor in my Prusa mk3s+ after getting temp errors and not...

#

AI Help

Yes, exposed wires from the heater can be a safety concern as they can potentially short circuit or cause electrical issues. It's important to properly insulate and secure all wiring in your 3D printer to prevent any hazards. Make sure to address the exposed wires before continuing with your thermistor replacement.

steel mauve Jun 28, 2024, 8:52 PM

#

neon sandal I was swapping my thermistor in my Prusa mk3s+ after getting temp errors and not...

I will take a wild guess: Yes. Do not turn it on

#

Replace that

neon sandal Jun 28, 2024, 8:55 PM

#

on it 🫡

bleak cobalt Jun 28, 2024, 8:56 PM

#

Yeah I would rather be safe than sorry on that lol

round kilnBOT Jun 28, 2024, 10:57 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

cinder thunder Jun 29, 2024, 6:51 AM

#

That looks cooked. Replace and if you have spares replace the heating block too

#Exposed heater wires?